Mechanical fit
Check the gearbox, output shaft and mounting features. Allow space for terminals, wiring and any rear shaft.
Review the drawings ↓NFP-GM12-N20V-EN
Compact geared output for your mechanism.
Compare the published winding and gearing configurations. Match the output shaft, operating point and mounting envelope to your assembly.
01 / TECHNICAL DATA
Choose the voltage, winding and reduction ratio together. Values below apply to the listed configurations; original units and tolerances are retained.
| Motor Model | NFP-GM12-N20V-EN-3V |
|---|---|
| Shaft Diameter | 4mm |
| Shaft Length | 10mm |
| Rated Voltage | 3V DC |
| No Load Speed | 31rpm ± 10% |
| No Load Current | ≤0.035A |
| Rated Torque | 0.5KG.CM |
| Rated Speed | 19rpm |
| Rated Current | ≤0.11A |
| Stall Torque | ≥1.2kg.cm |
| Stall Current | ≤0.2A |
| Signal Output After Deceleration | 1,468.3Pulse/cycle |
| Motor Model | NFP-GM12-N20V-EN-6V |
|---|---|
| Shaft Diameter | 4mm |
| Shaft Length | 10mm |
| Rated Voltage | 6V DC |
| No Load Speed | 63rpm ± 10% |
| No Load Current | ≤0.045A |
| Rated Torque | 1.0kg.cm |
| Rated Speed | 40rpm |
| Rated Current | ≤0.22A |
| Stall Torque | ≥2.5kg.cm |
| Stall Current | ≤0.4A |
| Signal Output After Deceleration | 1,468.3Pulse/cycle |
02 / MECHANICAL & ELECTRICAL INTERFACE
03 / DESIGN INTEGRATION
Check the gearbox, output shaft and mounting features. Allow space for terminals, wiring and any rear shaft.
Review the drawings ↓Select the winding for your supply and duty cycle. Check the listed rated and stall currents when choosing the controller.
Compare configurations ↑Define the required speed and torque at the output. Evaluate the selected ratio and motor in the finished mechanism.
Discuss your application ↗ENGINEERING ENQUIRY
Include the winding, gear ratio, target speed and torque, output shaft, duty cycle and expected quantity.